This morning I clecoed the roll bar and interior strap sections together. The ¼" tube I installed with RTV has set and I pulled the tube and wires through the large hole in the rear of the right side of the roll bar. I also trimmed the edges of the small snap bushing which goes in the #12 hole drilled in the bottom of the upper roll bar interior strap. I had to trim the edges of the bushing flange so it would snap in place between the forward and aft halves of the roll bar sections. I slid the bushing over the wires and snapped it in place.
I trimmed the roll bar support brackets in preparation for clecoing the roll bar in place.
