Today I started by building a tool cart. It is a small 16"x24" table with a bottom shelf and castors so I can roll it around the shop. It should be useful in moving tools and equipment around the shop when working on different parts of the airplane. I will put a some drawer liner on the top shelf and it will be finished.
I put the outboard and middle skins on the bottom of the right wing. I need to install the remaining clecoes and rivet the skin in place.
I also finished riveting the nutplates to the access hatch opening on the bottom of the left wing. The access hatch is for the stall warning device.
I also found another rivet that had not been set properly so I drilled it out and replaced it this afternoon.
