The parts from
Van's came in the mail today. I replaced
the broken corner stud/stand-off and installed the module to the panel and the
panel to the instrument supports. I
installed the screws holding the panel to the supports and instrument
shelf. It is looking pretty good. I ran the wiring harness through the
cushioned clamp but there is not enough space to run it through the snap
bushing in the stack support. I will
wire tie it to the wires before and after the bushing.
I removed the SL-40 radio from the tray. I attached the antenna to the tray. I am now ready to attach the tray to the supports.
